Category: Installation & Integration
News
-
Clamp-On Energy Meter Installation: Flow + Supply/Return Sensor Guide
An energy meter is only as good as its installation. Unlike a plain flow meter, a thermal energy meter has two measurement systems that must both be correct: the clamp-on ultrasonic flow sensors and a matched pair of supply/return temperature sensors. Get either one wrong and the BTU or kWh total drifts — even though…
-
Wiring a Compact Clamp-On Meter to 4–20 mA and RS485 Modbus: Integration Guide
A flow meter earns its place by getting data into the control system. If you are integrating a small-bore clamp-on meter with a PLC, SCADA or building controller, the outputs and how you scale them matter as much as accuracy. The YF-C3 is an RS485 Modbus flow meter with a simultaneous 4–20 mA channel and…
-
Magnetic Clamp-On Flow Meter: How Tool-Free Snap-On Mounting Works
The hardest part of ultrasonic flow measurement has never been the electronics — it is mounting the transducers correctly. Spacing, alignment and acoustic coupling decide whether readings are trustworthy. A magnetic clamp-on flow meter removes most of that human variable. The YF-C3 uses a patented magnetic snap-on bracket that is pre-assembled at the factory so…
-
Clamp-On Ultrasonic Flow Meter Installation: V-Method and Z-Method Guide
90% of clamp-on accuracy problems come from mounting. Location rules, pipe preparation and V/Z/N transducer methods explained in one guide.
-
Can a Clamp-On Flow Meter Be Installed Without Shutting Down the Pipeline?
Clamp-on ultrasonic meters mount on the outside of a live, pressurised pipe — no cutting, no hot tap, no drain-down, no shutdown. How live installation works, how long it takes, and the conditions that matter.
-
What Pipe Size Can a Clamp-On Ultrasonic Flow Meter Measure?
From small-bore DN15 lines to DN5000 transmission mains, clamp-on ultrasonic meters cover an extremely wide pipe size range. How diameter drives transducer and model selection, and where the limits are.
-
What Pipe Materials Can a Clamp-On Ultrasonic Flow Meter Measure?
Clamp-on ultrasonic meters measure through most common pipe walls — carbon steel, stainless, cast iron, copper, PVC, HDPE and lined pipes. Here is which work best, which need special care, and why entering the pipe material correctly matters.
-
How Do Clamp-On Flow Meter Outputs Connect to PLC, BMS and SCADA?
How a clamp-on ultrasonic meter talks to your control system: 4-20mA analogue, pulse/OCT, RS485 Modbus RTU and GPRS/4G cloud logging — when to use each, and how they wire into PLC, BMS and SCADA.